Paxton Demonstration Case - TCP/IP Manual de usuario descargar pdf (Pagina 2)

Connecting to a TCP/IP interface

Install the Net2 software on the PC. Connect the unit to the PC via a Network cable.

Run the Net2 Server Conguration Utility (Start/Programs/Net2) and select TCP/IP nodes.

Click on "Detect" the MAC address of the Ethernet interface will appear in the table. You should then go to the "IP

address conguration" tab and assign the IP address.

You can set up a new IP for the interface but if this is not in the same range as the PC, the device will no longer

respond until you connect to the device with a PC that is in the same IP range.

Some rewall/virus software or other wireless hardware can block the IP detection process. Disable these and try

to detect the interface again. Please contact Technical Support if you require further advice.

*The MAC address can be found on a label in the case and starts 00-xx-xx-xx

1 2 3 4

Sin comentarios

Paxton Demonstration Case - TCP/IP Manual de usuario Pagina 2