Paxton Net2 Caller ID reader Manual de usuario descargar pdf

LED indications

Power - 12v DC supply OK

Network - Connected to the Mobile phone network

Activity - The reader is receiving data from a mobile phone

Ins-30150 Net2 Caller ID reader

15/04/2011

Technical Support

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

01273 811011

[email protected]

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

Paxton

Installation

Insert the SIM card in its holder at the top right of the unit.

A drilling template for the plastic housing is available at < http://paxton.info/1715 >

If the device is to be installed where the mobile signal may be low, the antenna should be installed externally.

Secure the antenna by:

1. Internal - Remove the peel off paper from the adhesive strip and x within the enclosure.

2. Externally - Disconnect the SMA screw connection and route the cable through any of the cabinet push-out plugs

and x to a smooth surface.

Wire the Caller ID reader colour for colour to a Net2 ACU reader port within a maximum cable length of 15 metres.

Belden 9540 is recommended for all data cable wiring.

If a token reader is also tted, it is connected to the Caller ID's own reader port within a maximum cable length to

the Net2 ACU of 100 metres.

Power up the unit and conrm that the Power LED comes on. The Network LED will come on within a few minutes

once the unit is active on its GSM network.

To register the SIM, create an account on the Paxton website. < http://paxton.info/1713 >

The phone number will be supplied within 60 minutes of this process. There is a small monthly charge per SIM for

this service, however, no data charges are incurred as the caller ID is sent without making a full connection.

Connection to a Net2

ACU reader port

Power

redaeR

Control Unit

SIM CARD

Network

Activity

Net2

Caller ID reader

(Optional)

Antenna

1 2 3 4

01273 811011 1
Specications 2

Indice de contenidos

Pagina 1 - 01273 811011

LED indications Power - 12v DC supply OKNetwork - Connected to the Mobile phone networkActivity - The reader is receiving data from a mobile

Pagina 2 - Specications

10V DC 14V DC500 mA15 m- 20 °C + 55 °C200 mm 200 mm 75 mmSpecications Operating temperatureElectrical Environment Dimensions Min Max Width Height Dep

Pagina 3

Ins-30150 Net2 Caller ID reader Technical SupportTechnical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Pagina 4

Set the reader operating mode in the Net2 software to 'Paxton Reader' and the Operating mode to 'Token only'Enter the last 8 digit

Comentarios a estos manuales

Sin comentarios

Paxton Net2 Caller ID reader Manual de usuario

Busca en linea o descarga Manual de usuario para Para Casa Paxton Net2 Caller ID reader. Paxton Net2 Caller ID reader User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Para Casa Paxton Net2 Caller ID reader